Download Datalogic QuickScan QS6500BT

Symbologies
Telepen — continued
Telepen Data Group Characters
Once you’ve pre-set your desired Data Group Characters1 using the Data Group
Characters feature found in Chapter 5, Data Editing, you can choose to output up
to two of those pre-sets whenever a Telepen bar code is scanned.
NOTE
The options in this section set Data Group Characters
for the Telepen symbology ONLY. If you wish to enable
this feature for additional symbologies, turn to the
options in the section specific to the other symbology(s).
To set this feature:
1. Determine which Data Group pre-set(s) to output. You can select up to
two from the following:
Data Group 1 * Data Group 2 * Data Group 3 * Data Group 4
For example, your choice might be Data Group 2 only; Data Groups 1
and 3; Data Groups 3 and 4; or no Data Groups.
2. Scan the START bar code to place the imager in Programming Mode.
3. Scan the SET TELEPEN DATA GROUP CHARACTERS bar code.
4. Turn to Appendix B, Alpha-Numeric Pad and scan the digits representing
the Data Group designation(s) chosen in the first step above. A digit of
value zero (0) selects “no group.” For example, scanning 3 and 0 would
output only the character(s) set for Data Group 3 whenever a Telepen bar
code was scanned. Scanning digits 1 and 2 would output both Data
Groups 2 and 3. To select no Data Groups at all, scan 0, then 0 again.
5. Scan the SET bar code to accept the digits scanned.
6. Scan the END bar code to exit Programming Mode.
1. In that chapter, you can select which character(s) and position(s) to place Data Characters within
scanned data output.
240
QuickScanTM QS6500/QS6500BT