Download DIGITAL PRESSURE CONTROLLER MODEL 7250 MODEL 7250i

Bit 1
Bit 0
Reserved. 0.
Operation complete. Set for *OPC command.
Operation Status (OPER:EVENT, OPER:CONDITION, OPER:ENABLE)
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 12
Bit 13
Bit 14
Bit 15
Calibrating. Currently performing a calibration.
Settling. Control setpoint has not been reached. Pressure tolerance set by
SOUR:PRES:TOL
Reserved. 0.
Reserved. 0.
Measuring. The instrument is actively measuring.
Reserved. 0.
Reserved. 0.
Self-test in progress.
Reserved.
Reserved. 0.
Reserved. 0.
Reserved. 0.
Reserved. 0.
Program running.
Reserved. 0.
Questionable Status (QUES:EVENT, QUES:CONDITION, QUES:ENABLE)
Bit 0 Reserved.
Bit 1 Reserved. 0.
Bit 2 Time is questionable. Set when the clock has not been set.
Bit 3. Temperature is questionable. Sets when oven temperature is not within range.
Bit 4 Reserved. 0.
Bit 5 Reserved. 0.
Bit 6 Reserved. 0.
Bit 7 Calibration is questionable. Set when the unit has not been calibrated.
Bit 8 Pressure is questionable. Set when the pressure is overranged.
Bit 9 Reserved. 0.
Bit 10 Reserved. 0.
Bit 11 Reserved. 0.
Bit 12 Reserved. 0.
Bit 13 Reserved. 0.
Bit 14 Command warning. Set whenever a command ignores a parameter.
Bit 15 Reserved. 0.
5.5
6005 INTERFACE PANEL EMULATION
The DPC may be configured to emulate the IEEE-488 command set of the Ruska Single
Channel Interface Panel (Models 6005-701 and 6005-761). See the Interface Panel User’s
Manual for a description of the protocol. The DPC emulation has the following differences:
1.
2.
3.
4.
The DPC is always in Remote mode (Byte 1, Bit 1) .
All TI strip outputs must be written as OFF.
No special functions are implemented.
Any message written to the DPC that starts with a colon as the first character is
interpreted as a SCPI command.
5-9
REMOTE OPERATION