Download MtP Series & FieldPro Programmer`s Manual

O’Neil Emulation
O’Neil Emulation allows Printek printers to respond to commands designed to operate an O’Neil microFlash
printer. The commands that are supported are listed below.
Note: Items marked with an asterisk (*) are Printek extensions. Refer to the Printek Emulation section of
this manual.
Communications
Same as Printek Emulation
Line Printer Mode
Character Size and Line Spacing
Double Wide On
Double Wide Off
Double High/Wide On *
Double High/Wide Off *
Multiply Character Height
Select Double High and Double Wide
SO
SI
DC2 D
DC2 d
ESC H n
ESC ! n
Character Sets
Select Font (See Font Mapping, below.)
ESC w n
Horizontal Position
Backspace *
Horizontal Tab *
Carriage Return
BS
HT
CR
Vertical Position
Line Feed
Vertical Tab *
Form Feed (ESC E *)
Set Interline Spacing
Set Form Length
Advance From Q Mark
LF
VT
FF, ESC E
ESC A n
ESC C n
ESC Q n1 n2
Graphics
Select Graphics Mode
Begin Graphics
End Graphics
ESC V n1 n2
ESC B
ESC E
37