Download MTPX Plus 128 - Extron Electronics

Remote Control and Optimizing the Video, cont’d
Installing and Starting the Control Program
4-14
X2( = Port timeout interval
nnn.nnn.nnn.nnn
0 =1 off, 1 = on
0 = clear/none (default for Telnet connection)
1 = verbose mode (default for RS-232/RS-422 connection)
2 = tagged responses for queries
3 = verbose mode and tagged for queries
1 (= 10 seconds) - 65000 (default is 30 = 300 seconds = 5 minutes)
X2^ = IP address
X2& = DHCP
X2* = Verbose mode
N
Read global IP port timeout
Configure global IP port timeout
Read current port timeout
Read verbose mode
Configure current port timeout
Set verbose mode
Read DHCP on/off status
Set DHCP on or off
Read gateway IP address
Set gateway IP address
Read subnet mask
Set subnet mask
EX2^CI}
ECI}
EX2^CS}
ECS}
EX2^CG}
ECG}
EX2&DH}
EDH}
EX2*CV}
ECV}
E0*X2(TC}
E0TC}
E1*X2(TC}
E1TC}
Read IP address
Set IP address
IP setup
Command
(host to switcher)
ASCII command
IpiX2^]
X2^]
IpsX2^]
X2^]
IpgX2^]
X2^]
IdhX2&]
X2&]
VrbX2*]
X2*]
Pti0*X2(]
X2(]
Pti1*X2(]
X2(]
Response
(switcher to host)
Additional description
Another way to operate the switcher, to set the skew
adjustments, the level and peaking, and the output pre-peaking
(see "Optimizing the video", beginning on page 4-18), is via
the Windows®-based Matrix Switchers Control Program.
This program is contained on the Extron Software Products
DVD (included with the switcher). Run this program on a
PC connected to a serial port (i, j, and m on pages 2-5 and
2-6), Ethernet port (k), or USB port (n) on the switcher. The
program must be installed on a Windows-based computer and
cannot be run from the DVD.
N For details on operating the program, refer to the
MTPX Plus User's Manual, chapter 5, “Matrix
Software”.
Installing the program
N To run this program while your computer is connected
to an MTPX Plus 128 Configuration (USB) port, use
version 7.7 or newer of the Matrix Switchers Control
Program.
1.
Insert the DVD into the drive. The Extron software DVD
window should appear automatically.
N If the window does not self-open, run Launch.exe from the
DVD.
The Extron software DVD window appears.
2.
Click the Software tab.
3.
Scroll to the Matrix Switchers program and click
Install.
MTPX Plus Series • Remote Control and Optimizing the Video
Refer also to the MTPX Plus User’s Manual at www.extron.com.
MTPX Plus Series • Remote Control and Optimizing the Video
Refer also to the MTPX Plus User’s Manual at www.extron.com.
4-15