Download ETERNITY USER GUIDE

Eternity User Guide
8.
Visit each lock (no need follow the lock order)
Code Setting (For Keypad Lock User Only)
Make sure the lock is in the correct code mode (Either Permanent or
Temporary).
Default setting for the lock mode is “Permanent Mode”.
How to switch code mode:
Select Maintenance mission/Set Parameter Key tab. Uncheck or Check
the “Temporary Code” and input the check out time. Issue programming
key and visit lock. After two beeps, the lock is in the desired mode.
Permanent Code Setting
Steps to set permanent code
1. Open “Set Access Code Mission”, and select permanent code.
21