Download John Deere 2630 Display

Guidance
SHIFT TRACK SETTINGS tab
SHIFT TRACK SETTING tab allows setup of the following:
PC8706 —UN—22AUG05
• Shift On/Off ­ shift track feature can be turned on/off by
selecting or deselecting SHIFTS ON/OFF.
• Small Shifts Settings ­ Range 1—30 cm (0.4—12 in.)
Small shifts are active while AutoTrac is active.
Shift Left
• Large Shifts Settings ­ Range 30—406 cm (12—160
PC8707 —UN—22AUG05
in.).
NOTE: Large Shifts are disabled when AutoTrac is
active or when operating in Curve Track mode.
Re­Center
• Clear All Shifts ­ Used to clear all shifts for entire field,
PC8708 —UN—22AUG05
restoring original position of Track 0, and consequently
adjusting position of all tracks in field.
NOTE: AutoTrac has to be deactivated to use
this feature.
Shift Right
Available in Straight Track mode only.
TRACK SETTINGS tab. The amount is displayed under
the Shift Track buttons. To re­center line on vehicle’s
current location select RE­CENTER button.
Shift Track
Shift track is used to adjust position of machine left, center
or right of set track. Shift track can be used to compensate
for GPS drift. Drift is inherent to any satellite­based,
differentially corrected GPS system.
Shift Track shifts track 0, and all AB lines associated
with this track, right or left the pre­specified distance. An
operator may also "re­center" displayed line on Guidance
icon.
To move line to left, select SHIFT LEFT button. To move
line to right, select SHIFT RIGHT button. Each time button
is pressed, line will move the amount defined in the SHIFT
IMPORTANT: When using SF2 or SF1 Differential
Correction (or when using RTK Quick Survey
Mode) the track may drift over time or at
power cycles. Shift Track can be used to
compensate for GPS drift.
NOTE: RTK Absolute Base Mode is highly recommended
in high accuracy applications when repeatability is
needed. Only RTK Absolute Base Mode provides
consistent repeatability and accuracy.
OUO6050,00021E6 ­19­31AUG09­1/1
50­15
062111
PN=82