Download Hardware Preparation Guide

5.
Watch the screen carefully, and press the F9 key when prompted to access the ROM-Based
Setup Utility (RBSU).
Table 4-6 iLO Settings for HP ProLiant DL360 G4 Nodes
Menu Name
Submenu Name
User
Option Name
Set to This Value
Add
Create a common iLO user name and password for
every node in the hardware configuration. The
password must have a minimum of 8 characters by
default, but this value is configurable.
The user Administrator is predefined by default,
but you must create your own user name and
password. For security purposes, HP recommends
that you delete the Administrator user.
You must use this user name and password to access
the console port.
Network
DNS/DHCP
DHCP Enable
On
Settings
CLI
Serial CLI Speed
(bits/seconds)
115200 (Press the F10 key to save the setting.)
Perform the following procedure from the RBSU for each node in the hardware configuration:
1.
Make the following settings from the Main menu.
BIOS settings for HP ProLiant DL360 G4 nodes are listed in Table 4-7.
Table 4-7 BIOS Settings for HP ProLiant DL360 G4 Nodes
Menu Name
Option Name
Set to This Value
Set the following boot order on all nodes
except the head node; CD-ROM does not
have to be first in the list, but it must be
listed before the hard disk:
1. CD-ROM
2. NIC1
3. Hard Disk
Standard Boot Order IPL
On the head node, set the boot order so that
the CD-ROM is listed before the hard disk.
Advanced Options
Processor Hyper_threading
Disable
System Options
Embedded Serial Port
COM2
Virtual Serial Port
COM1
Press the Esc key to return to the main
menu.
BIOS Serial Console &
EMS
BIOS Serial Console Port
COM1
BIOS Serial Console Baud Rate
115200
EMS Console
Disable
BIOS Interface Mode
Command-Line
Press the Esc key to return to the main
menu.
2.
3.
Press the Esc key to exit the RBSU. Press the F10 key to confirm your choice and restart the
boot sequence.
Repeat this procedure for each HP ProLiant DL360 G4 node in the HP XC system.
4.5 Preparing the Hardware for CP3000 (Intel Xeon with EM64T) Systems
69