Download Partner Feature Code List For ACS


In Hybrid and Key mode, do not use this feature to add lines to the system after initial setup, because it changes the following features for individual lines back to
factory settings:
— Line Assignment
— Line Access Restriction
— Automatic Line Selection
— Line Ringing

To change line assignments without affecting other settings, use Line Assignment (#301).

If your system has a 1600 DSL module, the module is automatically assigned 16 lines. If you have less than 16 lines actually equipped for service, you may
remove the unequipped line appearances from the extension telephones by using Line Assignment (#301).

Transfer Return Rings (#105) programs the number of times a transferred call rings before it returns to an extension
By the factory setting, transferred calls return to the originating extension if they are not answered. However, you can program the transferred call to return to another
extension. And you also can program the number of times a transferred call rings before it returns to an extension.




Use this feature, which applies to all system extensions, to define the number of times a transferred call rings before it goes to the transfer return extension.
If you have a fax machine or an answering machine connected to the system, set Transfer Return Rings to a number greater than the number of rings at
which these devices answer.
The system does not start counting the number of rings for a transferred call (to determine when it goes to the transfer return extension if it is not answered)
until the transfer originator hangs up.
If you program Hunt Group Extensions (#505), make sure this setting is four or more rings. This setting allows the call to continue hunting to other group
extensions if it is not answered by the first group extension where it rings.
To change the number of times a transferred call rings before returning to the transfer return extension:
1.
2.
3.

Press feature +(00)+(system program)+(system program)+#105 at extension 10 or 11.
Enter a setting (0—9; 4 is the factory setting), or press (Next Data) until a display with the desired amount of rings appears, similar to the following:
Transfer Return
5 Rings
Select another procedure, or exit programming mode.
Recall Timer Duration (#107) changes the length of the timed signal, or switchhook flash
Use this feature to change the length of the timed signal, or switchhook flash, generated by the system Recall feature (as well as by the Recall option used in Auto
Dial and Speed Dial numbers). Recall sends this timed signal over the telephone line to the local telephone company or PBX to which the system is connected.
Typically, you use the Recall feature to access a PBX, central office, or Centrex feature, such as Call Waiting. Your local telephone company can tell you the correct