Download Draper SC1 Programming instructions

Motor Name:
510S2RH-RTS
Torque in Nm:
Volts: 120
10
Amps: 1.3
RPM:
38
Parallel Wire:
Yes
Roller Diameter Choices: 2” aluminum, 2” steel,
2 1/8” steel, 3” steel, 3 1/8” steel
Product (s) Used In: Motor Flexshades and Skylights as
needed
Min. Shade Width: 29” om
With Crank override 34” om
Standard Motor Lead Length:
6’
Lead Type:
Part No: C047.157
Optional Lead Lengths:
12’ and 24’
Plug Options: 3-prong
18-2 w/ground
Limit Type: Remote Set
Used in:
Flexshade and Skylight Hardware Only
Dual Headboxes Not Recommended
Controls that motor can wire into: This motor is not wired into any controls. It is operated through RTS
transmitters, both hand held and wall switch.
Installation Procedure:
Special Notes:
1. Install Brackets, endcaps, or box to mount shade
This motor has a built-in radio receiver, and it
is an up-charge on regular shade pricing.
2. Test motor and set limits and channels using
remote
3. Let electrician connect to wiring
Page 90 of 120