Download Siemens C10 User guide
Transcript
HWC_AppendixB.fm CLI command reference Category OSPF Syntax Comment <hostname>:ip# show routes displays a numbered table of static routes <hostname>:ip# no route #n clears static route #n OR no route <x.y.z.a> clears static route; has to match an existing route with address x.y.z.a <hostname># ip <hostname>:ip# (no) protocol ospf <hostname>:ip# ospf <hostname>:ospf# routerid <value> only 1 protocol can be enabled on the AC area <area-id> areatype <default|stub|nssa> config ospfinterface <0|1|2|3> <hostname>:ospf.0# (no) ospfinterface Port has to be made router port during esa configuration linkcost <val|default> auth <on|off> authkey <password> hello <val|default> dead <val|default> retx <val|default> txdelay <val|default> IP Addresses Management <hostname># Port Table B-1 182 interface <hostname>:interface:# eth0 selects interface to configure <hostname>:interface: eth0# hostname hostname '<string>' CLI commands A31003-W1010-A100-1-7619, July 2005 HiPath Wireless Controller, Access Points and Convergence Software V3.0: User Guide