Download TKA 9110 UC Coffeemaker Training Program

Transcript
30
Disassembly – Gas burner (2)
To remove gas burner:
•
After noting connections, disconnect wires to all parts, including gas valve, igniter, flame
sensor, Hi-limit & NTC. Be careful to not damage igniter.
•
Remove burner screws, including screws holding burner bracket to base and combustion
chamber and screws holding burner to bracket. All screws are T-20 Torx.
Disconnecting wires
from gas valve
Screw
Gas valve & burner
Removing front
burner base screw
Removing rear
burner base screw
All screws T-20
Removing rear
burner base screw
Burner screws
Burner ring screws
Gas valve screws
LP burner without ring
1st Edition/Revision 4 (1/19/04)