Download Ricoh AP600N Setup guide

Memory Unit Type C (SDRAM Module)
Memory Unit Type C (SDRAM Module)
Important
❒ Before touching the Memory Unit,
touch something metal to discharge any static electricity. Static
electricity can damage the Memory Unit.
❒ Do not subject the Memory unit to
physical shocks.
D Remove the two screws holding
the controller board in place.
Note
❒ Use a coin or similar object if the
screws do not turn easily.
2
❒ The removed screws are required in step L.
A Check the contents of the box for
the following items:
• Memory Unit
• Installation Guide
B Be
sure to check the following
points:
• The power switch is turned off.
• The interface cable is unplugged from the printer.
Note
❒ If the Duplex Unit is not attached, go to step D.
ZKGX280E
E Pull out the handle of the controller board.
C If
the Duplex Unit is attached,
push down the lever on right side
(A
A) and pull out the Duplex Unit
until it stops (B
B).
ZKGX370E
ZKGX320E
25