Download Siemens SIMATIC NET Operating instructions

Transcript
Guidelines for Installing Networked Automation Systems in Buildings
5. Fit the connector
– Fit the lower cable clamp into the grooves of the connector casing.
– Fit the cable into the connector casing so that the braided shield with the
copper band lies in the cable clamp
– Fit the upper cable clamp into the grooves of the connector casing and
screw it tight
– Assign pairs of wires to the screw terminals
You will find the assignment necessary for a particular cable type in Section
LEERER MERKER “Preassembled Industrial Twisted Pair Cables”.
– Secure the conductors in the screw terminals
– Screw the cover on to the connector casing
5 12 3 10
Shield foil
Figure 7-10
7-34
ÓÓÓÓ
ÓÓÓÓ
ÓÓÓÓ
ÓÓÓÓ
Braided shield
wrapped with copper
band
15-Pin Sub-D Male Connector Fitted to the Standard Cable
SIMATIC NET Twisted-Pair and Fiber-Optic Networks
C79000-G8976-C125-02