Download Alesis ProLinear DSP Specifications
Transcript
2 Operations Operational Overview The ProLinear DSP offers three methods of control: • • • the front panel buttons and LCD the PC software the Input Level control on the rear panel Through these controls the following functions are managed: • Volume • Parametric EQ • • Frequency Gain Q Speaker ID/Channel assignment Input Level monitoring Volume Volume is controlled in two ways: by the rear panel Input Level control and by the Gain Trim parameter accessed from the front panel (see the Program Mode description in this section). The Input Level control adjusts the signal level going into the Integrated DSP Module. Setting this too high could result in distortion, and setting it too low could result in unnecessary noise or loss of resolution. The Gain Trim parameter adjusts the output gain from the Integrated DSP Module into the amplifiers, and can be adjusted within a range of -18dB to +17dB. The same care must be taken when setting this level so as to avoid distortion and noise. Parametric EQ The ProLinear DSP has a four-band parametric equalizer that allows a great deal of flexibility in “voicing” the speaker (setting its tonal balance). Each of the four bands of the equalizer consists of three settings: frequency, gain and Q. • Frequencies can be set in 1/6th octave increments within a range of 20Hz-20kHz. • Gain adjustments may be made for each band within a range of –12dB to +6dB. The changes from -10 dB to +6dB are made in 0.1dB increments, while the changes from –12dB to -10dB are measured in 1 dB increments. • Q values (the frequency range covered by a band) range from 0.25 to 4.00 octaves. It is possible to manually select Q values of HSH (high shelving), LSH (low shelving) HP (high-pass filter). For definitions of these settings, see page 27. 14 Note: For proper gain staging, the lowest possible noise floor, and the most accurate representation of the signal, we recommend the volume be adjusted by the rear panel control. Use the Gain Trim feature only as a temporary measure.