Download DK Digital CDB-700 User manual
Transcript
Cable connections: SMPS connection, 4-pole minifit plug Second actuator connection, 6-pole minifit plug or blind plug Handset / FS connection, 10-pole modular jack / 6-wire standard cable. Fig. 1 Step 1: Fig. 2 Step 2: Insert the cables in the sockets. Insert the cables into the cable lock. Make sure the O-rings on the cables are fully inserted. Make sure that the correct cables are placed in the corresponding holes. Fig. 3 Step 3: Attach the cable lock and secure it with screws. The tightening torque should be 0.4 Nm. Cable connection and cable lock: Tighten the two screws with approx. 0.4 Nm torque to secure the cable lock. Page 47 of 108