Download Beta EVO 2T Specifications

Transcript
A
Before inserting the electronic control box
into its support, it is recommended to set
the multi-pin connector in place and pass
the cable that connects the engine to the
main system.
Place the multi-pin connector of the control
box in such a way for it to enter its relative
space in the control box support.
Slide the cable to the main system along
the right engine bracket and fasten it with a
clamp (refer to the arrow).
Insert the control box in such a way for the
housing on the elastic control box to engage with flap A. Insert the multi-pin connector well into the control box.
Detailed control box and cable assembly.
4 .5 Connecting the engine
cable to the main system
and mounting the rear
mudguard
A
B
Before remounting the rear mudguard you
must reconnect the engine to the main system by means of the quadripole and monopole connector.
Connect connectors A and B to the counterparts of the main electrical system and fasten them to the cables with clamps.
Pull the cables forward to the left side of
the frame until the connectors enter beneath the frame itself.
Then reassemble the rear mudguard by
tightening its bolts with a torque of 5Nm after having connected the relative connector
to the back light.
4
Mounting the engine on the vehicle and repositioning the components
4 .4 Electronic control box
Monopole and quadripole connectors.
55