Download MTD 18A-V17-800 Programming instructions

Special NC Functions 11-11
NC Programming 17VRS
Edge status bits for the TLD command:
Group name
Group information
Symbol
Write
access
Edge orientation incorrect
Edge orientation correct/incorrect
o
WZM
EL
1
1
0
L1 incorrect
L1 correct/incorrect
1
WZM
EL
2
1
0
L2 incorrect
L1 correct/incorrect
2
WZM
EL
3
1
0
L3 incorrect
L1 correct/incorrect
3
WZM
EL
4
1
0
R incorrect
R correct/incorrect
r
WZM
EL
5
1
0
Type
Bit
Value
Reserved for future enhancements (bits 6 - 8)
Wear status
Edge done/not done
d
WZM
WZ
9
1
0
Warning limit reached/not reached
w
WZM
WZ
10
1
0
Reserved for future enhancements (bits 11 - 12)
User edge status 1
User edge status bit 1
any
ANP/BED
WZ
13
1
0
User edge status bit 4
any
ANP/BED
WZ
16
1
0
.
.
.
User edge status 4
Abbreviations:
General requirements for the
TLD command
WZM:
BED:
WZ:
= Tool management
= Operator
= Tool-specific status bit
EL:
PL:
ANP:
= Setup list-specific status bit
= Location-specific. status bit
= User-specific programs on PLC or CNC
• An NC variable can be used instead of the constant.
• A mathematical calculation cannot be used instead of a constant or a
NC variable.
• The optional parameters do not need to be set.
• The commas used to separate the parameters must always be used.
Optional parameters for the TLD
command
• If the process [0..6] is not declared, the CNC will used the current
process where TLD is used.
• If the "addressing" parameter [0/1] is not declared, the CNC will use
"0" as the value and will interpret the following two parameters as the
storage unit and location.
• If the tool index number [1..999] is not declared, the CNC will use the
index number of the corresponding primary tool.
• If the edge is not declared [0..9], the CNC will use "0" as the value,
thereby accessing the basic tool data.
• The parameter status [1..32] does not need to be declared unless a
tool or an edge status bit is being accessed.
DOK-MTC200-NC**PRO*V17-ANW1-EN-P