1
Download MTD 18A-V17-800 Programming instructions
Transcript
Tool Corrections 5-31 NC Programming 17VRS [P2] [P3] Contour Violation [Ps1] R [P6] [P1], [P7] [P5] [P4] R [P0] [P1] tool radius programmed starting point of the contour corrected starting point of the contour Fig. 5-22: Tool path compensation with closed contours Removing Tool Path Compensation at the End of the Contour The end point of the contour [Pe1] which was corrected with tool path compensation is located above the end point [Pe0] of the programmed contour perpendicular to the prior direction of motion. [Pe1] R [Pe0] [Pe0] R [Pe1] [Pe0] [Pe1] R R [Pe0] [Pe1] tool radius programmed end point of the contour corrected end point of the contour Fig. 5-23: End point of tool path compensation The cancellation of tool path compensation requires an additional move in the working plane which can only be performed in conjunction with a programmed linear movement (see Fig. 5-24). DOK-MTC200-NC**PRO*V17-ANW1-EN-P
