Download Sea-doo Speedster 5894 Specifications

Section 08 ELECTRICAL
Sub-Section 03 (IGNITION SYSTEM TESTING PROCEDURE, 787 ENGINE)
10. Press 8 to choose Save + Quit (even if item
no. 8 is not visible on the display, it is active
when you select it).
11. Press Enter to confirm yes you want to save
modifications to the MPEM.
12. You must see Operation successful. This
confirms that the new timing has been stored
in the MPEM.
13. Unplug communication cable from safety lanyard post on craft.
At this point, you can install the craft’s safety lanyard and start the engine to check the effect of
the correction on the timing marks. If further adjustment is required, repeat the procedure.
14. Press Off to close the programmer.
NOTE : The MPEM module features a permanent (non-volatile) memory and keeps the
ignition timing programmed even when the craft’s
battery is disconnected.
'
08-03-7