Download Marantz CDR500 User guide
Transcript
The numbers between parentheses refer to the fold-out. This CD-Recorder can be used to record directly or through a (pre-) amplifier from any digital or analog audio source. In addition, the appliance can be used as a regular CD player. Read how to connect the CD-Recorder based on the possibilities your other audio equipment offers. Please refer to the operating instructions for your other audio equipment first. Unbalanced analog connections 1 For recording and playing, connect the CD-Recorder to other equipment based on the diagram below: CD RECORDER/CD PLAYER CDR500 CDR PLAY MODE CD IR Recordable ReWritable STORE POWER STANDBY ERASE REC.M FINAL INPUT REC LEVEL/SELECT MENU TIME TEXT PROG LEVEL HEADPHONE DELETE CANCL PUSH ENTER 0 The following options are available: CD ANALOG OUT 10 CDR ANALOG IN OUT L L - Balanced analog connections - Unbalanced analog connections - Digital SPDIF connections - Digital Optical connections L L L L L - Digital cascade connections R R R R R 3 R 4 R 5 INPUT INPUT OUTPUT INPUT ANALOG DEVICE ANALOG DEVICE OUTPUT ANALOG SOURCE Balanced analog connections 2 1 Select INPUT SELECT switch (34) to ANALOG L/R (RCA). For recording, connect the analog balanced cable from the CD-Recorder to a source based on the diagram below: 3 ANALOG OUT COLD(-) IN R L PLAY MODE L BALANCED IN R -TRIM- L CD RECORDER/CD PLAYER CDR500 CDR L CD IR R Recordable 0 +22 0 R +22 ReWritable (REF=+16dBu/0dBFS) STORE STANDBY POWER ERASE REC.M FINAL INPUT REC LEVEL/SELECT MENU TIME TEXT PROG HEADPHONE INPUT SELECT LEVEL DELETE CANCL PUSH ENTER 0 10 CDR 3 R L BALANCED 2 1 - R L Note: Never use the PHONO input. ANALOG SOURCE 2 For DUAL-Mode playback (See page 17), connect cable 5 between the ANALOG CD OUTPUT-sockets on the CDRecorder and the ANALOG INPUT sockets of an amplifier e.g. TAPE IN, CD or AUX. DUAL-Mode playback is the function that the deck 1 and the deck 2 on this CD-Recorder can play the songs separately at the same time. Set INPUT SELECT switch (34) to BALANCED IN. 3 ANALOG OUT COLD(-) IN R L R L L BALANCED IN R -TRIM- L 0 +22 0 R +22 INPUT SELECT (REF=+16dBu/0dBFS) When this CD-Recorder is shipped, it is already set to +16dBu/0dBFS at the MAX-REC-LEVEL. If you want to change the level, rotate TRIM control (33) to adjust input level for both L and R. ANALOG OUT COLD(-) IN R L R L L BALANCED IN R -TRIM- L 0 +22 0 R +22 (REF=+16dBu/0dBFS) INPUT SELECT Note: Use the digital output for exact calibration in combination with a digital signal analyzer. 5 CDR500N P01-14 (E) 5 9/7/00, 5:12 PM ENGLISH INSTALLATION