Download Security Ranger III User guide

Installation & Operation Manual
High Resolution (HR) E-Series Extended Status
Figure 93: Extended Status - HR E-Series
The status indicators described below apply for an ORION ME or SE (mobile mode) endpoint when connected to an
HR E-Series meter.
Status Indicator
Description
EP Prog
Endpoint is reporting that it has been reprogrammed via IR.
EP Tamper
Endpoint is reporting a tamper condition. This condition occurs when the wire between the
E-Series meter and the endpoint is cut or shorted, or the encoder is not connected.
Mobile Mode
Endpoint is communicating in mobile transmission mode.
EP Low Battery
Endpoint is reporting a low battery condition.
Encoder Error
E-Series meter is reporting a device error to the endpoint.
Empty Pipe
E-Series meter is reporting a no flow condition in the pipe.
Low Temp
E-Series meter indicates the low temperature limits have been exceeded.
ENC End of Life
E-Series meter is reporting to the endpoint that the encoder battery life indicator has been
activated.
No Usage
E-Series meter is reporting a no usage condition to the endpoint.
Reverse Flow
E-Series meter is reporting a reverse flow condition to the endpoint.
Leak
E-Series meter is reporting a potential leak condition to the endpoint.
Sensor Error
Endpoint is reporting a sensor error or meter alarm other than empty pipe or low temp.
Encoder Information
Description
Size & Type
The size and type for which the E-Series meter was programmed.
Units
The units of measure as defined by the E-Series meter: cubic meters, cubic feet, gallons,
imperial gallons or liters.
Encoder
The encoder protocol.
Dials
Encoder dial resolution (8) as reported from the E-Series meter.
Reverse Flow Total
The total reverse flow units measured by the E-Series meter.
NNOTE: Refer to the E-Series Installation and Programming manuals, ESM-IOM-01-EN and ESM-IOM-02-EN, for a detailed list
of encoder status indicators.
February 2013
Page 57