Download Conair CSC User guide

Checking the Encoder
When the encoder is working properly, the measurement displayed will count up to
the preset and reset to zero.
1 Check all connections.
2 Check the encoder cable for damage. If necessary, replace.
3 Check the connector that attaches the cable to the encoder. Internal wiring
may be shorted out if this connector is not handled properly.
4 Check the encoder itself. There should be no play in the shaft.
5 If all else fails, contact Conair Customer Service. See Appendix A.
WA R N I N G : D e l i c a t e e q u i p m e n t
THe encoder is a delicate piece of equipment. Any rough handling can
damage fragile parts.
6
Troubleshooting
Tr o u b l e s h o o t i n g l 6 - 1 7