Download Asante 10BaseT Installation guide

Transcript
10T Hub Ch 2 Page 6 Thursday, August 22, 1996 4:25 PM
Installation
▲
Page 2-6
Only one shared port is available on the 10T Hub/8 for
either BNC or AUI connection. This port is equipped
with two connectors: a BNC connector and an AUI connector. The hub autosense circuit can detect which connector is in use and no switch needs to be set. Just make
sure that only one of the connectors is connected.
There is no such restriction on the 10T Hub/12. Both
the BNC port and the AUI port can be used at the same
time.