Download DelfiScan M80 Manual

Enter Configuration
Ì$+;Î
Exit and Save Configuration
DATA FORMAT
Ì$-?Î
CHARACTER REPLACEMENT
‹ disable character replacement
ÌEO0mÎ
This parameter allows up to three characters to be replaced from the barcode read. These
substitutions are stored in memory. To define each character replacement:
c
Read one of the following character replacement codes:
first character replacement
ÌEO1pÎ
second character replacement
ÌEO2sÎ
third character replacement
ÌEO3vÎ
d
From the Code Identifier Table in Appendix B, read the Code Identifier for the desired code
family.
0 = character replacement will be effective for all code families.
e
From the Hex/Numeric Table read two characters corresponding to the Hex value (00-FE) which
identifies the character to be replaced. For Wedge and USB-KBD interfaces, it is also possible to
read the Special Key(s) on page 53.
f
From the Hex/Numeric Table read two characters corresponding to the Hex value (00-FE) which
identifies the new character to replace. For Wedge and USB-KBD interfaces, it is also possible to
read the Special Key(s) on page 53.
FF = the character to be replaced will be substituted with no character, that is, it will be
removed from the code.
56