1
Download Vicon IX 2000 L System information
Transcript
MXhardware_Reference.book Page 6 Monday, April 30, 2007 1:56 PM MX Control Card Configuration GPO Output Status Events The GPO outputs status events after the remote action has been triggered. You can configure other devices in your system to read these events and respond accordingly, as illustrated in the following examples. The example in Table A-4 shows the status events output by the GPO after the remote action has been triggered by a third-party treadmill (where High=5V and Low=0V). Table A-4: GPO control output status—third party treadmill Output Status Vicon System Event GPO 1 GPO 2 GPO 3 GPO 4 Low Low — — Idle (no capture in progress) High Low — — Armed (prepared for capture) High High — — Capturing The example in Table A-5 shows the status events output by the GPO after the remote action has been triggered by a Kyowa-Dengyo Force Plate (where High=5V and Low=0V). Table A-5: GPO control output status—Kyowa-Dengyo Force Plates Output Status A-6 Vicon System Event GPO 1 GPO 2 GPO 3 GPO 4 High — — — Capturing Low — — — Idle (no capture in progress) — Zero +CAL Balance -CAL Reserved for use by KyowaDengyo Force Plates. For details, contact your local representative. Vicon MX Hardware System Reference
