Download Evolis Dualys User`s guide

NOTE!
Although the cleaning signal has been activated, the printer will continue to work.
It is also possible to start a cleaning sequence without waiting for the cleaning signal
of the printer. This action is carried out by pressing the push button from the Control
Panel for few seconds. In this case, repeat all the operations above.
Cleaning of the print head
Use: cleaning swabs
Cleaning cycle: each time you load a new ribbon
The print head is cleaned when cleaning the interior of the printer (see preceding section). However,
in order to preserve the original printing quality and reduce the incidents caused by an excessive
presence of ink on the surface of the print head, it is recommended that you clean it regularly using
the cleaning swabs provided with the UltraClean cleaning kit.
ATTENTION !
It is very important to protect the print head and all other associated components from any
electrostatic discharge.
The print head is a fragile element. To avoid damaging it:
Before cleaning the print head, disconnect the printer from the mains.
■ Respect the cleaning cycles
■ Never place the print head in contact with sharp of metal object.
■ Avoid direct contact of the surface of the print head with fingers. Changed print quality
or even permanent degradation of the print head could result.
■
To clean the print head, proceed as follows:
2. Open the
printer cover
and locate the
print head.
3. Switch the
printer off.
Then, gently rub
the swab along
the print head for
a few seconds.
1. Take a new swab
and press on the stick
to let the liquid out.
IMPORTANT !
Following a cleaning cycle, wait 2 minutes for the cleaner to evaporate entirely before using
the printer.
20