Download DGH MS 2000 Owner`s manual

MS2000
MiniSteam Residential
Owner’s Manual
29. Run control wiring from the
humidistat and air flow switch, to
the humidifier unit and enter one
of the electrical connection fittings
on the bottom of the humidifier
unit.
30. Tighten the strain relief
connector around the wires.
31. Connect the wires per one of
the following control wiring
diagrams, directly to the bottom of
the circuit board. Figure 26 is the
standard wiring diagram. If you
desire for the humidifier to
activate the heating fan whenever
there is a call for humidity, then
use the following control wiring
scheme instead. A small, 24 Vac
DPST relay will be needed.
(See Figure 27 below left)
Figure 26
Figure 27
13
Systems, L.L.C.