Download Cooper Security 9751 User guide

2. Programming Commands
KEYSWITCH DISARM
KEYSWITCH ARM
FULL
Event
DOWNLOAD SUCCESS
EXPANDER MISSING
EXPANDER MISSING RESTORE
FORBI MISSING
FORBI MISSING RESTORE
JAMMING
PASSWORD DEFAULTS LOADED
PROG MODE START
PROG MODE END
TD (Time and day) RESET
TX BATTERY TROUBLE
USER CODE CHANGED
USER CODE DELETED
OS
CS
409
409
SIA Code
RS
TA
TR
TA
TR
XQ
RH
LB
LS
JT
XT
JV
JX
CID Code
412
137
137‡
137
137‡
380
627
628
625
384
-
Notes:
1.
If Command 143, option 1 is selected, all messages with a CID Code are sent. If
option 0 is selected, the restores marked with ‡ are not sent.
2.
The control unit logs an Anti-Mask event to the zone number one below that assigned
the Anti-Mask type. See page 8 for an explanation of the Anti-Mask zone type.
132: Send Tampers as Burglary
Some Alarm Receiving Centres (ARCs) experience problems if a control unit
sends "restore" messages using SIA, wrongly interpreting them as "user
restores". When using SIA reporting, Command 132 enables you to program
the control unit to send tampers as alarms.
Option
0
The control unit sends all SIA messages as specified in Command
131 (default).
1
For full alarm response, the control unit sends tampers as burglary
(BA) and sends Contact ID 130 in place of Contact ID 137.
Notes:
1.
Compliance with PD 6662 / prEN 50131-1: 2004 (see page 85) at Grade 3 requires
that Command 132 is set to 1.
2.
If Command 132 is set to 0, Command 37 must also be set to 0.
3.
Fast Format and plug-by outputs send tampers as alarms only if no tampers are
allocated using Commands 151-158, 191-198, 211-218. As the default settings do
not include tamper allocations, the normal operation of these outputs is to send
tampers as alarms.
497096, issue 3
Page 53