1
Download ARM7TDMI technical reference manual
Transcript
AC and DC Parameters 7.16 Breakpoint timing Figure 7-15 shows the ARM7TDMI processor synchronous interrupt timing. The timing parameter used in Figure 7-12 is listed in Table 7-12. MCLK BREAKPT nCPI nEXEC nMREQ SEQ Tbcems Figure 7-15 Breakpoint timing Note In Figure 7-15, BREAKPT changing in the LOW phase of MCLK (to signal a watchpointed store) affects nCPI, nEXEC, nMREQ, and SEQ in the same phase. Table 7-15 Breakpoint timing parameters 7-20 Symbol Parameter Parameter type Tbcems BREAKPT to nCPI, nEXEC, nMREQ, SEQ delay Maximum Copyright © 1994-2001. All rights reserved. ARM DDI 0029G
![[U4.83.11] Opérateur POST_RCCM](http://vs1.manualzilla.com/store/data/006374258_1-02ec80959c2c4816a7bdfe94ffd80332-150x150.png)
