Download IP WatchDog

IP WatchDog HWg-WR02a
HW group
Primary configuration of Ethernet parameters
The primary configuration of the IP WatchDog’s Ethernet parameters (IP address, network mask
and gateway) can be done in the following ways:
UDP Setup – the IP WatchDog must be located on a local Ethernet network segment.
RS-232 Setup – In case no Ethernet connection is available.
TCP Setup – only if you know the IP address of the device! TCP setup allows setting the
same parameters as Serial Setup. It also allows changing the parameters remotely via
Ethernet / Internet.
Configuring the IP address – UDP Config
UDP Config utility – root directory of the
supplied CD (Windows and Linux versions).
Available for download at www.HWgroup.com
Software > UDP Config.
Click the icon to launch UDP Config.
The program automatically looks for
connected devices.
To search for devices, click the Find
Devices icon.
The program searches for devices in your local network. Individual Poseidon units are identified by
their MAC addresses (printed on the label at the bottom side of the unit). Double-click a MAC
address to open a basic device configuration dialog.
Configure network parameters
IP address / HTTP port (80 by
default)
Network mask
Gateway IP address for your
network
Device name (optional)
Click the Apply Changes button to save the
settings.
Enter the IP address of the device into your
WWW browser and press Enter. You will get
a Main Page of the www interface.
Detailed information on configuration
methods over www interface can be found in
the chapter called Device configuration via
WWW.
www.HWgroup.com
9 / 30