1
Download Sharp R-230L Operating instructions
Transcript
7. Basic applications 7.7 Wire saw application using plunging pulleys Special stands 7.7a 7.7b Pivoting pulleys (to saw head) 200 mm dia. Pivoting pulleys (to saw head) 200 mm dia. Hole 162 mm dia. Hole ∅ 162 mm Length of cut Length of cut Tubular extension 2″ dia. Tubular extension 2″ dia. Tubular extension 2″ dia. Radius at end of cut Tubular extension 2″ dia. Radius at end of cut 20–30 cm 20–30 cm Pivoting plunging pulleys 140 mm dia. Pivoting plunging pulleys 140 mm dia. 7.7c Pivoting pulleys (to saw head) 200 mm dia. Length of cut Tubular extension 2″ dia. Radius at end of cut Pivoting plunging pulleys 140 mm dia. Tubular extension 2″ dia. 20–30 cm Desired depth of cut 7.7d Note When cutting over a length of 2–3 m, the plunging pulleys must always be positioned 20 to 30 cm below the desired depth as a slight curve always remains at the end of the cut. 18 Printed: 08.07.2013 | Doc-Nr: PUB / 5069762 / 000 / 01
