Download Asus S62F Specifications

BIOS SPECIFICATION
LAN Controller
Dynamic
D800~D8FF
IRQ16
Wireless (802.11abg)
Static
IRQ17
Ricoh MS
Dynamic
IRQ19
Ricoh SD
Dynamic
IRQ19
FE8FEC00~
FE8FECFF
FDFFF000~
FDFFFFFF
FE8FF000~
FE8FF0FF
FE8FF400~
FE8FF4FF
Note: The resources of dynamic devices will be changed if users change the settings. The IRQ 9 is
reserved for SCI of ACPI O.S.
4.6 POWER MANAGEMENT
In addition to C1, C2/C2E, C3 and C4/C4E states at system full on state, the S62F platform must also
support suspend states described in next two sections.
4.6.1 ACPI-Enabled Environment
Table 4-5 Power Management in ACPI mode
Power State
S3
S4
Soft Off
Entry Event Source
Wake Up Event Source
z
Standby Timer Time out
z
PME (onboard LAN, CardBus card)
z
Select “Standby” in O.S.
z
High Definition Audio (modem)
z
LID switch
z
USB (USB devices)
z
Power button
z
RTC Alarm
z
Internal keystroke
z
Power button
z
Standby Timer time out
z
PME (onboard LAN, AC Only)
z
Select “Hibernate” in O.S.
z
RTC Alarm
z
LID switch
z
Power button
z
Power button
z
Select “Shut Down” in O.S.
z
RTC Alarm
z
LID switch
z
Power button
z
Power button
z
PME (onboard LAN, AC Only)
Note : LID won’t trigger a wake up.
4.6.2 ACPI 2.0
S62F BIOS is ACPI 2.0 compliance. It supports Windows XP Native Processor Performance Control.
In Windows XP, the processor performance control policy is linked to the Power Scheme setting in
the standard control panel power options applet. No additional UI is employed to set the policy.
Windows XP defines four control policies for processor performance control:
Constant
Adaptive
Degrade
None
Always runs at lowest performance state
Performance state chosen based on CPU demand
Starts at lowest performance state, then uses linear performance reduction (stop
clock throttling) as battery discharges
Always runs at highest performance state
The following table shows the relationship between the Power Scheme selected and the control
policy used.
Table 4-6 Power Scheme Table
6-9