Download FastStream SC 5700

Transcript
6.0 Monitor Storage, Configurations
You may determine the performance of drives attached to the FastStream using various displays and tests in
ExpressNAV Storage Manager.
The following instructions assume you have already
set up at least one RAID group.
The ATTO FastStream collects various metrics to
measure performance for physical drives attached to
the FastStream during normal system operation and
drive initialization and verification.
CAUTION
New performance data is updated every 60
seconds which impacts performance
slightly, even if you minimize the browser
window. Exit the ExpressNAV Storage
Manager completely whenever you need
maximum performance.
Health and Status Monitor page
The Health and Status Monitor page is the first
page you see when you open the ExpressNAV
Storage Manager after completing the configuration of
at least one RAID group. You may return to it at any
time by clicking on the Monitor button on the left hand
side of the screen.
1 If you are not already in the ExpressNAV
Storage Manager, type the IP address of your
appliance in a standard browser as found in
2
17
ATTO Technology Inc. FastStream SC Installation and Operation Manual
Using the ExpressNAV Storage Manager on
page 27, click Enter Here, type in your user
name and password, and click OK.
The Health and Status Monitor page appears.
If you click Details, added information about
each parameter appears on the Configuration
Display page (refer to Configuration Display
page on page 18).