Download FastStream SC 5700

Transcript
CLI command explanations
Command Line Interface commands are listed alphabetically with explanations of what they are used for, their
defaults and syntax.
CAUTION
Using CLI without contacting an ATTO
technician is not recommended because
changing parameters may cause loss of
data and/or disruption to performance and
reliability of the FastStream.
The ExpressNAV Storage Manager is the
preferred method to manage the
FastStream. Refer to Interface Options on
page 27 for details.
AutoMap
Automatically assigns a subset of source protocol LUNs to a
subset of target destination devices visible to the unit. The unit
reports a five-second delay while it scans for devices. All
previous maps are deleted.
If FCMultiNode is enabled (multiple node):
AutoMap <fp>
SaveConfiguration command required
If FCMultiNode is disabled (single node): AutoMap
SaveConfiguration command required
AutoResume
BlockDevIdentify
Lights the LED of a disk drive. Use either RAID group name and
member index, or block ID.
BlockDevIdentify <Group name> [BlockDevID | member
index]
BlockDevIDStop
Turns off the IO LED of a previously identified disk drive.
BlockDevIDStop
BlockDevScan
Lists all currently-connected physical block devices and any
potential RAID group association. Each block device listed is
assigned a unique index at the time of the scan which is used to
identify block devices for other CLI operations. If you wish to
force rediscovery of all block devices, use the flush parameter.
However, if you use the flush parameter, all existing RAID
groups are forced offline until member block devices are
discovered.
BlockDevScan <flush>
BridgeModel
Reports specific model and firmware information.
Regulates the AutoResume features for interrupted rebuild
and erase operations at startup. If no group name is specified,
all existing RAID groups are affected.
get BridgeModel
Default: enabled for AutoResume Rebuild
disabled for AutoResumeErase
set AutoResume [Rebuild | Erase | All ] [enabled |
disabled] <group name>
Specifies an ASCII name assigned to the unit to identify
individual units. It is not the World Wide Name. Changes take
effect immediately. The name may be contain up to 8
characters.
BlockDevClean
Removes any RAID configuration data from the block device
with the specified block ID.
CAUTION
All RAID group setup information is lost
and you lose all RAID group data.
BlockDevClean [BlockDevID]
BridgeName
set BridgeName [name]
SaveConfiguration Restart command required
get BridgeName
ClearEventLog
Clears the contents of the EventLog. No new entries are
recorded until the operation is completed.
ClearEventLog
Date
Regulates the current date for this unit. The date range is
1/1/2000 to 12/31/2099.
set Date [MM] / [DD] / [YYYY]
get Date
vi