Download Samson S2000 Operating instructions

Start-up – Settings
Limiting the signal pressure:
Reading direction for left
attachment of pneumatic
connections
Pressure limit
Default: No
If the displayed data appear upside down,
proceed as follows:
Turn
→ Code 16
Turn
→ Code 2
Press
→ Code 16 blinks.
Press
→ Code 2 blinks.
Turn
→ Required direction
Turn
until the required pressure limit
(1.4/2.4/3.7 bar) appears.
Press
7.4
to confirm reading direction.
Limiting the signal pressure
If the maximum actuator force may cause
damage to the valve, the signal pressure
must be limited.
Enable configuration at the positioner before
activating the pressure limit function:
Note: If no settings are entered within
120 seconds, the enabled configuration
function becomes invalid.
Press
ting.
7.5
to confirm the pressure limit set-
Checking the operating
range of the positioner
To check the mechanical attachment and the
proper functioning, the valve should be
moved through the operating range of the
positioner in the
manual operating mode
with the manual set point.
Selecting
manual operating mode:
Operating mode
Default MAN
Configuration enabled
Default: No
Turn
→ Code 0
Turn
→ Code 3, display: No
Press
→ Code 0 blinks.
Press
→ Code 3 blinks.
Turn
→ MAN
Turn
→ YES
Press
→ display
Press
. The positioner changes to the
manual operating mode.
58
EB 8384-4 EN