Download Conair 300 User guide

Te s t i n g t h e I n s t a l l a t i o n
4 Press the START button.
(continued)
Start
If everything is installed correctly:
• The green light on the start button will illuminate.
• The process and regeneration blowers and LEDS will turn on.
• The process and regeneration heaters and LEDS will turn on.
• The desiccant wheel starts turning.
5 Press the STOP button.
Stop
• The green light on the start button will illuminate.
• The process and regeneration blowers turn on and the display
LEDS will illuminate.
• The regeneration heater turns on and the display LED will
•
illuminate.
The desiccant wheel starts turning.
6 The test is over. If the dryer performed the normal operating sequences as outlined, you can load the hopper and begin operation. If it did not, refer to the
Troubleshooting section of the User Guide.
Installation l 3-15
3
Installation
If everything is installed correctly:
• The blowers will continue running as needed to cool the heaters
(until both heaters are less than 150°F {66°C}).