Download Wohler AMP2-VS User guide

Ch a p te r 6 I n pu t/ O u tp ut M od u le s a nd O pt io n s
A d di n g/ Re m o vi n g M od ul e s
Adding a Dolby D/E/DD+ Card
To add a Dolby D/E/DD+ Card, follow the instructions below.
Note:
It may prove helpful to place the monitor with the rear panel
facing you for this procedure.
1.
Place the monitor on a solid, static-free surface and remove the
power cord(s).
2.
Using a small Phillips screwdriver, remove the top cover.
Figure 6–10
3.
821116:
154
Remove Bottom Screw
Pull the monitor so that it slightly hangs over the edge of the
surface on which it is sitting, and remove the screw on the bottom
as shown in Figure 6–10 above.
A M P2 -1 6 V S e r i e s U s e r G u i d e
© 2 0 1 4 Wo h l e r Te c h n o l o g i e s , In c . A l l r i g h t s r e s e r ve d .