Download Comtech EF Data Vipersat CDM-570 User guide

V i p e r s a t C o nf i g u r a t i o n
Entering O at the command prompt toggles the Voice Switch Detection
command for the CDM-570/570L between Enabled and Disabled. When
enabled, a voice data-stream will be detected, causing the CDM-570/570L to
send a switch request to the VMS to switch from STDMA to SCPC mode.
Video Switch Detection
This menu item appears for Remote modems only.
Video Switch Detection is one of the Application switching commands that
provides for a dedicated SCPC connection when an H.323 video call is made
over the satellite network.
Entering I at the command prompt toggles the Video Switch Detection
command for the CDM-570/570L between Enabled and Disabled. When
enabled, a video data-stream will be detected, causing the CDM-570/570L to
send a switch request to the VMS to switch from STDMA to SCPC mode.
ToS Switch Detection
This menu item appears for Remote modems only.
One of the four automatic switching functions that the Vipersat CDM-570/570L
is able to perform is ToS (Type of Service) Switching. ToS is defined by an
eight bit field within an IP packet header that is used to set up per-hop-based
QoS rules for prioritizing packets. Because the ToS field remains untouched by
most encryption methods, ToS switching provides an alternative means of
SCPC switching when encryption prevents the detection of SIP and H.323
protocols.
ToS detection occurs in the Remote modem which only looks at traffic that is
passed in the LAN-to-SAT (Remote to Hub) direction. Once the ToS Switch
Detection feature is enabled, the Remote modem will send an ASR to the VMS
when a packet stamped with the ToS is detected. The ASR contains the destination IP address of the ToS stamped packet, the desired SCPC rate, and the VMS
Switch Type (policy #). If available hardware and bandwidth exist, the VMS
will establish the SCPC carrier automatically.
Entering T at the command prompt in figure 3-41 toggles the TOS Switch
Detection command for the CDM-570/570L between Enabled and Disabled.
When enabling ToS switching, the ToS switching control parameters must be
defined as described in the section “ToS Switching Parameters” on page 3-45.
Applying a ToS value to an application (VoIP, IPVC, or priority data) through
either preservation or classification packet stamping allows the Vipersat switching system to function in an encrypted network. Normally in a non-encrypted
Vipersat network, packets are classified by the Remote CDM-570/570L using
protocol classification detection and the results are forwarded to VMS via
3-34
Vipersat CDM-570/570L User Guide