Download Zebra TTP7030 Specifications

Programming
Logotypes
Logotypes
Up to 16 logotypes can be stored in the flash PROM of the printer. The logotypes can
be positioned and printed out with commands ESC g or ESC L.
The exact number of logotypes and their sizes is determined by the total amount of memory
used for fonts, logotypes and loaded firmware. Make a test printout to see how much memory
is available.
Loading
Windows software that converts black and white BMP bitmap files to logotypes and load them
into the printer is available on the Zebra web site. If you need to load logotypes in a nonWindows environment, use the ESC & 1 command.
The time required by the printer to process logotype data, excluding transfer time from the PC,
is typically 15 to 20 seconds, per logotype. During this time, any data sent to the printer will be
lost.
File Format
A header containing information about the logotype number, size and logotype name shall
define each loaded logotype. Immediately after the header follows the actual bitmap of the
logotype.
ESC & 01H <Header><Bitmap>
Header
Byte 0
Logotype number used to identify the logotype when printing.
Byte 1
X size measured in bytes.
Byte 2
Y size measured in pixels.
Byte 3—15
A logotype name that will be printed on test printouts.
Bitmap
The bitmap must have exactly (X size * Y size) number of bytes. 1=black, 0=white dot.
Bit No. 7 in byte 0 represents the top left corner of the logotype.
X size
0
7
Byte 0
Y size
02/11/2009
TTP 7020™/TTP 7030™ Technical Manual
P1003636-001
71