Download BENDIX GEN 4 GEN 5 ABS User guide

Antilock
The antilock section displays the current number of
sensors and modulators of the system.
Odometer
The odometer section displays the current odometer
reading. The trip odometer reading is the odometer
mileage since the odometer was cleared. The service
odometer is the mileage left before service is needed.
Figure 18
Additional Axle for Trailer
The additional axle for trailer will display if the axle is a
lift or not lift axle only for configurations of 4S/2M and
4S/3M.
Figure 23
Tire Size
The tire size section displays the current rolling radius
value programmed into the ABS ECU. These values
are for both tires on one axle. These are dependent on
the circumference of the tire, and how many complete
revolutions the tire makes over one mile. These values
should be obtained from the tire manufacturer and
typically are different for each tire model. The tool
assumes a tone ring with 100 teeth.
Figure 19
In Cab Trailer Lamp (for EC-30™ ECU ONLY)
There is a configuration item for the In Cab trailer
lamp (PLC). The possible configurations are enabled
(meaning PLC is supported) or disabled (meaning PLC
is not supported).
Figure 20
Figure 24
Retarder
The retarder section displays the current control of the
retarder.
Note: The actual value of tire size may be slightly
different than the value inputted due to scaling of
calculation.
Figure 21
Figure 25
ATC
The ATC section displays the current configuration of
the Automatic Traction Control system.
ESP
The ESP section displays a list of ESP parameters
stating if they are enabled or disabled. Additionally, a
listing of the stability sensors indicating they’re mounted
as standard or inverted.
Figure 22
Figure 26
10