Download Audio multi media recording micro system
Transcript
29112 rev1 1/9/06 09:40 Page 9 Press timer on the remote to set Disk playback The unit will power on automatically and enter the presetting Source DISC mode as soon as the presetting time arrives. NOTE: The unit will power on and enter the TUNER mode automatically if there is no disc in the disc tray or there is no music files in the USB or SD/MMC card. Volume Press SKIP +/- button to locate the item VOLUME, press PLAY/PAUSE button to confirm, and again use the SKIP +/buttons to adjust the volume. The unit’s volume. 30 15 The display shows the number of tracks and time of disk playback as whole after the player reads the disk successfully. 4 In Mp3 mode, the display does not show the time of disk playback as a whole. 5 Press PLAY/PAUSE button to begin CD playback; press this button again to pause playback. Press SKIP buttons once to skip the current track and go back to the beginning of this track, press this button continuously to go back to corresponding tracks at back. 05 When the SLEEP function is activated, the player goes to standby mode the moment playback or broadcasting reaches the Preset Sleep time. While the SLEEP function is activated, you may press SLEEP button once to check the amount of time. Press SLEEP button twice to change your sleep setting. 3 When in play mode, Press SKIP + button once to skip the current track and play the next track, press this button continuously to go to corresponding tracks ahead. Sleep time in a sequence as follows: 45 Insert a disc onto the CD tray. Skipping tracks and searching between tracks Press the SLEEP button on the remote control in music stop or play mode or Radio broadcasts, the player enters the sleep mode, press the button again the display changes. 60 2 Press this button in music play mode to stop playing. Sleep function (falling asleep to your Micro System) 90 Press FUNCTION button until the player enters CD mode. Stop button The unit’s volume will increase the presetting value automatically. 120 1 off When not in play mode, press and hold SKIP buttons to initiate high-rate scanning between tracks; release one of them to begin playback of music at normal speed. Repeat modes In CD playing mode, press REPEAT button once to repeat the current track;the LCD shows the icon for single track repeat. Press REPEAT button twice to repeat tracks as a whole; the LCD shows the icon for all tracks repeat. 9 wwww .m.m oroprhpyhryicrihcahradrsdasu.cdoiom.com 9 8