Download ABB TB82PH Operating instructions

TRANSPORT
PRODUCT IDENTIFICATION
After factory calibration, the instrument is packed in a
carton, intended to provide protection from physical
damage.
The following data plates shown in Figure 1 identify
the instrument.
The Nameplate (Reference A) provides information
concerning the product identity code (i.e.,
nomenclature), product name, operating voltage
range, output type, serial number, test personnel
badge number, and dielectric strength verification
stamp.
STORAGE
The instrument does not require any special treatment
if stored as dispatched and within the specified
ambient conditions level listed in the Specification
section. There is no limit to the storage period.
The Agency Approval label (Reference B) is included
when the transmitter is purchased for compliance with
hazardous area regulations (e.g., intrinsic safety
protection) for a specific country (e.g., CSA, FM, or
CENELEC).
HANDLING
The instrument does not require any special
precautions during handling, though care should be
observed.
2175 LOCKHEED WAY
CARSON CITY,
NEVADA 89706
EC conformance is identified using a CE label
(Reference C).
Optional tagging specified by
customer
requirements
is
provided
via
a
supplementary tag (Reference D).
82 TWO-WIRE TRANSMITTER SERIES
Reference C - EC Conformance Label
INTRINSICALLY SAFE EEx ia IIC T4
II 1G
- 20 C
Ta
60 C
CENELEC
LCIE 98.E6066 X
Ui=24V Ii=250mA Ci=0 Li=0mH Pi=1.2W
2175 LOCKHEED WAY
CARSON CITY,
NEVADA 89706
82 TWO-WIRE TRANSMITTER SERIES
NONINCENDIVE T5
CLASS I; DIVISION 2; GROUPS A, B, C, D
CLASS II; DIVISION 2; GROUPS F, G
CLASS III
INTRINSICALLY SAFE T4
CLASS I; DIVISION 1; GROUPS A, B, C, D
CLASS II; DIVISION 1; GROUPS E, F, G
APPROVED
CLASS III
WHEN CONNECTED PER DRAWING P0807
Vmax=24V Imax=250mA Ci=0 Li=0mH
MAX. AMBIENT TEMPERATURE: 60 C
OUTPUT TO SENSORS IS SUITABLE FOR NONINCENDIVE FIELD
WIRING WHEN USED WITH ABB SENSORS PER DRAWING P0807
NEMA 4X
2175 LOCKHEED WAY
CARSON CITY,
NEVADA 89706
TYPE 4X
82 TWO-WIRE TRANSMITTER SERIES
Reference D - Optional Tag
CLASS I; DIVISION 2; GROUPS A, B, C, D
CLASS II; DIVISION 2; GROUPS E, F, G
CLASS III
INTRINSICALLY SAFE Exia T4
CLASS I; DIVISION 1; GROUPS A, B, C, D
CLASS II; DIVISION 1; GROUPS E, F, G
CLASS III
WHEN CONNECTED PER DRAWING P0806
Vmax=24V Imax=250mA Ci=0 Li=0mH
Product Nomenclature
‘X’ Signify Product Options
TAG
Carson City, NV.
OUTPUT TO SENSOR IS SUITABLE FOR NONINCENDIVE FIELD WIRING FOR
CLASS I LOCATIONS WHEN USED WITH ABB SENSORS PER DRAWING P0806
TB82ECX2XXXXX
TB82ECX2XXXXX
9 - 32 V dc, Profile Type 113
C arso n C ity, N V U .S.A Pho ne 7 75-883 -4366
Reference B
9 - 32 Vdc, Profile Type 113
Carson City, NV U.S.A Phone 775-883-4366
Reference A
Figure 1 – Product Identification
I-E67-TB82FF-2A February 13, 2002
4