Download MUTOH ValueCut Series User guide

Preparing for a job
Operation Instructions SC Cutting Plotters
ADJUSTING THE KNIFE DEPTH
Two types of high quality knife holders are available for the SC cutters.
No matter which type of knife holder you are using, adjusting the knife depth is a very
important parameter when it comes to making high quality outputs. Always make sure that
the knife blade protrudes enough, but not too much out of the knife holder.
1. Knife Holder
2. Vinyl
3. Backing
4. Cutting blade
TO ADJUST THE KNIFE DEPTH, PROCEED AS FOLLOWS :
STANDARD KNIFE HOLDER
OPTIONAL KNIFE HOLDER WITH NONIUS
1) Hold the body (2) in one hand and
adjust the depth by using the set
screw (3).
1) Loosen the base part of the cutting knife.
To do this, take the base part in your left
hand and twist the ring slightly.
Page 12
AP-75026 Rev 1.0 - 11/01/00