1
Download Instrument Control Toolbox User`s Guide
Transcript
To Instrument To Instrument Send simulation data to instrument Library Instrument Control Toolbox Description The To Instrument block configures and opens an interface to an instrument, initializes the instrument, and sends data to the instrument. The configuration and initialization happen at the start of the model execution. The block sends data to the instrument during model run time. The block has no output ports. The block has one input port corresponding to the data sent to the instrument. This data type must be double precision. Note: The To Instrument block can be used with these interfaces: VISA, GPIB, Serial, TCP/IP, and UDP. It is not supported on these interfaces: SPI, I2C, and Bluetooth. Dialog Box Block sample time The Block sample time parameter is the only setting outside of the dialog box tabs. The default value of -1 sets the block to inherit timing. A positive value is used as the sample period. Hardware Configuration Tab The Hardware Configuration tab is where you define the settings for communications with your instrument. You have two choices about establishing an interface: 24-33
