1
Download Agilent Technologies E8257C PSG Specifications
Transcript
Assembly Replacement Inner Instrument Cover Inner Instrument Cover Tools Required • T-10 driver Removal Procedure Refer to Figure 2-2 for this procedure. 1. Disconnect the power cord. 2. Remove the outer-cover from the signal generator. Refer to "Outer Instrument Cover" on page 2-5. 3. Place the signal generator flat and upright with the front panel facing you. 4. Using the T-10 driver, remove the twelve screws (1) from the inner cover (2). 5. Remove the inner cover. Replacement Procedure • Reverse the order of the removal procedures. • Torque all T-10 screws to 9 in-lbs. 2-7
