Download Duratrax Axis Specifications

RADIO ADJUSTMENTS
❏ 45. Turn on the transmitter and receiver.
❏ 42. Press the “L” shaped boot onto the bottom
housing of the air filter. Using one of the included tiestraps, secure the boot onto the bottom housing. Cut
the excess portion of the tie-strap to avoid interference.
❏ 46. Slide the rod collars and fuel tubing that engage
the brakes so that when the car is at an idle the brakes
are slightly on. Test this by rolling the Axis on a flat
table or the floor and applying the brakes using the
transmitter. Move the rod collars on the other side of
the brake levers so that they will push the levers back
when accelerating.
❏ 43. Screw the bottom and main filter housing
together. Note: Overtightening will strip the threads.
❏ 47. Tighten the rod collar that retains the throttle
❏ 44. Place the air filter onto the carburetor. Using the spring so that the spring cannot move back and forth
but not so much that the spring is tight. The rod collar
at the other end of the throttle linkage should be
tightened against the rod connector as shown.
remaining included tie-strap, secure the air filter to the
carburetor. Cut the excess portion of the tie-strap off to
avoid interference.
13