Download INSTRUCTION MANUAL
Transcript
❏ D. Using the holes in the strap as a guide, drill 1/16" [1.6mm] holes into the bottom of the fuselage. Install, then remove two #2 x 3/8" [9.5mm] Phillips wood screws into the holes, apply a few drops of thin CA to the holes, allow to harden, and remount the strap with the screws. ❏ E. Tighten the set screw in the collar. ❏ F. Mount the tail wheel with the small, nylon retainer. Mount the Main Landing Gear ❏ 1. Use a 1/2" and 7/16" open-end wrench to mount an axle to each landing gear. Use a metal file to grind a flat spot on the end of both axles. ❏ 4. Slide the elevator and rudder pushrods into the guide tubes in the fuselage. Connect the clevises to the secondfrom-the-outer holes of the horns. Slide the silicone retainers over the clevises. Refer to this photo for the following three steps. ❏ 2. Mount the wheels to the axles with a collar on both sides held on with the 3mm screws and threadlocker on the threads. ❏ 5. Place the elevator and rudder servos in the servo tray in the fuselage. Same as you did with the aileron servo(s), connect the rudder and elevator servos to your receiver and battery and turn on the radio. Center the trims and find the correct orientation for the servo arms that will be 90-degrees. Cut off the unused arms. ❏ 6. Mark, cut, bend and connect the pushrods to the servos the same way you did for the ailerons. After you mark the pushrods, it will be easier to bend and cut them if you disconnect the clevises from the horns on the other end. ❏ 7. The same way you mounted the aileron servo(s), mount ❏ 3. Mount each wheel pant to the landing gear with two 4-40 x 1/2" [13mm] Phillips screws and threadlocker on the threads. Be certain to use threadlocker because there are no lock washers. the elevator and rudder servos with the servo screws that came with them—don’t forget to harden the screw holes with a few drops of thin CA after installing, then removing the screws. 12