Download Dedicated Micros Digital Sprite Lite Setup guide

Function
Description
Verbose messages
This will send a SMS message in a readable format to a mobile devices
(e.g. mobile phone).
Note: This format is not supported in standard SMS Servers.
Callback profile
This identifies the route the return message, from the Operator mobile
device, will take. The return message must contain the SMS command
password, callback IP address (IP address of the remote PC with the
Viewer application) and the command to action the Digital Sprite 2 to call
the remote station.
SMS command
password
This is the password to enable the SMS commands to be initiated and
will be included in the return text from the Operator.
Last signal
strength
This is a read only section and identifies the signal strength of the GSM
module.
Last bit error rate
This is a read only section and will detail the error rate of the GSM
module.
Function
Description
Service Centre
Number
This page is specific to the GSM module connected to the Digital Sprite
2, this is the number for the service centre that will be responsible for
the SMS message.
GSM PIN Number
GSM/SMS Port
Dedicated Micros
This is the pin code for the SIM card in the mobile device that will
receive the SMS message. If any changes are made to this page the Pin
number must be re-entered each time.
This is the port address that will be used for the SMS message to be
transmitted/received, the options are Serial 1 or Serial 2.
Page 67