Download ETC VCC-28 Installation guide

Transcript
In the Properties window click on the Recording circle (Figure 11). Click the OK button (Figure 12).
.
Figure 11
Figure 12
The Wave In (recording level) window will appear. Adjust the volume to the recommended level
(Figure 13). Close out the Wave In window (Figure 14), and any other windows left open, and your
VCC-28 is ready to be configured with WAVE Dispatch Communicator software.
Figure 13
Figure 14
NOTE: The VCC-28 utilizes standard Windows/Linux USB audio device drivers. If the unit is
disconnected the settings may revert to default levels. These levels should be checked upon
reconnection in the event the VCC-28 becomes suddenly disconnected or loses power.
VCC-28 Installation Guide with WAVE
Page 19 of 33
Essential Trading Systems Corp.