Download Cisco 5428 - SN Router System information

Chapter 12
Command Line Interface Reference
fcswitch domainid
Examples
The following example sets the switched zoned fabric domain ID for the storage router to 42:
[SN5428-2A]# fcswitch domainid 42
*** Warning: Changing domain ID in an operational fabric will cause traffic disruption
Do you want to continue? [(yes/no (no)] yes
The following example sets the switched zoned fabric domain ID for the storage router to 5 and enables
the lock, which prevents the domain ID from being changed by the zoned fabric.
[SN5428-2A]# fcswitch domainid 5
*** Warning: Changing domain ID in an operational fabric will cause traffic disruption
Do you want to continue? [(yes/no (no)] yes
[SN5428-2A]# fcswitch domainid lock enable
Related Commands
Command
Description
fcswitch enable
Enable all FC interfaces.
fcswitch interop-credit Set the data buffer credit capacity for all FC ports.
fcswitch zoning
autosave
Configure the storage router to participate in FC switched zones.
fcswitch zoning
default
Select the level of communication between the storage router and devices in
the fabric where there is no active zone set.
fcswitch zoning merge Set zoning merge compliance.
interface fc? diag
Set the named FC interface into diagnostic mode for testing purposes.
interface fc? enable
Enable the named FC interface.
interface fc? loopback Initiate a loopback test on the named FC interface.
show fcswitch
Display global configuration information for storage router FC interfaces.
show fcswitch eport
Display FSPF protocol information.
Cisco SN 5428-2 Storage Router Software Configuration Guide
78-15471-01
12-139